2008 Honda Accord Wheels Problems

LOW TIRE PRESSURE LIGHT ON DASHBOARD STAYS LIT CONSTANTLY (YEARS!); EVEN AFTER BRAND NEW, PROPERLY INFLATED TIRES ARE INSTALLED. ON FLORIDA TURNPIKE FRIDAY 7/27/18 VERY FORTUNATE THAT TIRE MADE NOISE SO I PULLED OVER, AS TIRE INSIDE SIDEWALLS RUBBER WAS DISINTEGRATED/GONE WITH STEEL THREADS SHOWING! TPMS DASH LIGHT IS KNOWN DEFECT TO HONDA; BUT THEY WANT TO CHARGE $90 TO TELL YOU THAT! I'M EXTREMELY LUCKY TO NOT BE IN HOSPITAL OR MORGUE TODAY!

THE TPMS LIGHT ON THE CLUSTER PANEL TURNS ON AT HIGHWAY SPEEDS. I'VE ROUTINELY CHECKED THE TIRE PRESSURE FOR PAST THREE MONTHS ON COLD MORNINGS AND WARM TIRES. THE TPMS LIGHT TURNS OFF ON IT OWN AFTER AN HOUR OF HIGHWAY DRIVING OR ONCE YOU SWITCH THE ENGINE OFF (IT DOESN'T COME BACK ON UNTIL YOU DRIVE AT HIGHWAY SPEEDS AGAIN FOR AT LEAST 30-60 MINUTES).

NORTH AMERICA TIRES MODEL PRIMACY MXV; TIRES UNDER 5 YEARS OLD HAVE DRY ROT

BOTH WHEEL BEARINGS REQUIRED REPLACEMENT AROUND 120K MILES. LOUD HUMMING NOISES COMING FROM THE REAR OF THE CAR. CHANGED OUT BOTH HUB ASSEMBLIES AND NOW IT SOUNDS QUIET AGAIN. SEEMS A BIT PREMATURE TO HAVE TO CHANGE OUT THE PARTS. *TR

TL*THE CONTACT OWNS A 2008 HONDA ACCORD COUPE. THE CONTACT STATED THAT THE WHEEL RIM ON THE VEHICLE WHICH WAS MANUFACTURED BY HONDA WAS DEFECTIVE. THE MANUFACTURER USES A CLEAR COAT ON THEIR WHEEL RIMS WHICH CAUSES WATER TO ENTER UNDERNEATH, WHICH HAS CAUSED CORROSION. THE VEHICLE WAS INSPECTED BY THE DEALER AND COULD NOT DIAGNOSE THE FAILURE, BUT CLAIMS THAT THE CONTACT APPLIED CHROME CLEANER TO THE WHEEL RIM WHICH MAY HAVE CAUSED THE FAILURE. THE MANUFACTURER WAS CONTACTED AND OFFERED NO ASSISTANCE. HE THEN TOOK THE VEHICLE TO A TIRE COMPANY TO INSPECT THE WHEEL RIM AND THEY INFORMED HIM THAT THEY WERE DEFECTIVE AND SHOULD BE REPLACED. THE VEHICLE HAS NOT BEEN REPAIRED FOR THE WHEEL RIMS. THE FAILURE AND CURRENT MILEAGE WAS APPROXIMATELY 6,350. UPDATED 3/8/11 *CN THE CONSUMER STATED NO CLEANERS OR CHEMICALS HAVE BEEN USED ON THE RIMS. THE CONSUMER BELIEVED THERE WAS A DEFECT WITH THE RIMS. UPDATED 08/08/11

MAKE : HONDA MODEL : ACCORD MODEL YEAR 2008 OTHER ESSENTIAL INFORMATION - I WANT TO BRING TO YOUR ATTENTION THAT THE INSIDE OF THE HONDA ALLOY WHEELS ARE NOT SEALED OR PAINTED FROM THE FACTORY. THE WHEEL IS ALREADY CORRODING THE ALUMINUM WITH PITS WITH METAL MISSING. AFTER 2 MORE WINTERS THE SALT ON THE ROADS WILL DANGEROUSLY WEAKEN THE WHEEL STRENGTH LEADING TO FAILURE AT SPEED. THIS IS A REAL HIDDEN DANGER THAT I THOUGHT SHOULD BE LOOKED INTO SINCE HONDA DEALER SEES NO PROBLEM WITH THE CORRODING ALUMINUM. IF THE WHEELS WHERE SIMPLY PAINTED OR CLEAR COATED FROM THE FACTORY ON THE INSIDE LIKE THEY ARE ON THE OUTSIDE THEN THIS WOULD NOT BE BECOME THE HIDDEN DANGER THIS TYPE OF WHEEL WILL PRESENT TO THE UNSUSPECTING PUBLIC. *TR